Specifications
Parameter |
Typ |
Max |
Unit |
Maximum operating current |
|
200 |
mA |
LED voltage |
|
9 |
V |
Stability of current |
0.5 |
|
% |
DC Voltage to the driver |
|
12 |
V |
DC Current to the driver |
|
1 |
A |
Supply voltage |
110 |
240 |
V |
Power consumption |
|
20 |
W |
Size |
120x65x30 |
|
mm |
LED fixture cable length |
70 |
|
cm |
Pin Configuration
Instruction Manual
Setup
1. Connect the 12V DC to the receptacle on the left side of the controller box.
2. Connect the fixture cable to the receptacle “LED” on the right side the controller box.
3. Confirm that the potentiometer labeled “Current” is fully counter-clockwise to 0mA position.
4. Insert the diode in to the fixture head of the cable, in accordance polarity.
Operation
1. Toggle the “Power” switch up to the “On” position.
2. Rotate the “Current” potentiometer clockwise to the desired value, the display will show the driving current. (The digital display could not show the current if the current is over 200mA.)
3. Rotate the “LIMIT ADJ” to change the maximum limit current. Please read the diode datasheet before running the LED diode, do NOT turn the current over the diode maximum current.
4. Once the operation is complete, rotate “Current” counter-clockwise back to 0mA
5. Turn of the “Power” down to the “Off” position.
6. Safe to remove diode from the fixture of the cable.