Specifications
Computer controlled operation – via provided software control application
Stand alone operation – via built-in keypad and display
Built-in USB port – required for initial configuration and computer controlled operation
Parameter |
Specification |
Unit |
||
Control current range (1,2) |
0.015-0.5 |
0.03-1.0 |
0.06-2.0 |
A |
Current limit(1,2) |
0.2-0.5 |
0.2-1.0 |
0.2-2.0 |
A |
Current display resolution |
0.5 |
1.0 |
2.0 |
mA |
Compliance voltage |
>=4.8 |
V |
||
Photodiode current range(1) |
5 ranges (5-5000) selectable by software |
uA |
||
Maximum TEC current |
Stable operation regime, 3.0 Transient regime, 4.0 |
A |
||
TEC current limit(1) |
0.4-4.0 |
A |
||
Operation mode(1) |
(a) Constant current (b) Constant output power (c) External modulation (bandwidth 500kHz@3dB for sinusoidal modulation) |
|
||
Temperature control loop parameters (Proportional - Kp, and Integral - Ti) (1) |
Three ranges (selectable in software) |
|
||
External power supply |
+5VDC, 5A (included) |
|
||
Power consumption |
typ. <25 |
W |
(1) User configurable via Software Control Application (GUI)
(2) DIL mount is rated 1A continuous current
Additional information
Download PC control software for QCLDD-2.
Either 14-pin DIL mount, or 14-pin butterfly mount is included with the controller. If purchased together, this controller will be shipped preconfigured for operating with laser diode, superluminescent diode, or semiconductor optical amplifier as a complete turn-key system.
In the butterfly mount option, type I, type II, and a custom routing board are included. The custom routing board allows the user to wire a user-defined pin-out assignment. To change routing boards first disconnect the power supply from the QCLDD-2, remove the back plate of the QCLDD-2, and carefully pull out the routing board applying an even pull on both sides of the board. Then align the desired routing board with the QCLDD-2 sockets, confirm that the arrows marked OUTSIDE are pointing to the outer side of the QCLDD-2, and gently push the routing board all the way down. Re-assemble the back plate.
The QCLDD-2 also includes the AC-DC power supply adapter, the USB cable, and the software control application.